Influence of electrospray deposition on C₆₀ molecular assemblies

• Antoine Hinaut,
• Sebastian Scherb,
• Sara Freund,
• Zhao Liu,
• Thilo Glatzel and
• Ernst Meyer

Beilstein J. Nanotechnol. 2021, 12, 552–558, doi:10.3762/bjnano.12.45

• important for scanning probe studies at the atomic or molecular level. For large or fragile organic molecules, where sublimation cannot be used, high-vacuum electrospray deposition is a good alternative. However, because this method requires the introduction into vacuum of the molecules from solution, clean

• conditions are more difficult to be maintained. Additionally, because the presence of solvent on the surface cannot be fully eliminated, one has to take care of its possible influence. Here, we compare the high-vacuum electrospray deposition method to thermal evaporation for the preparation of C60 on

• method can yield single isolated molecules accompanied by surface modifications. Keywords: alkali halide; Au(111); bulk insulator; C60; electrospray; electrospray deposition; fullerene; high-vacuum electrospray deposition (HV-ESD); molecular assembly; nc-AFM; NiO; single molecule; thermal evaporation

Biomimetic and biodegradable cellulose acetate scaffolds loaded with dexamethasone for bone implants

• Aikaterini-Rafailia Tsiapla,
• Varvara Karagkiozaki,
• Veroniki Bakola,
• Foteini Pappa,
• Panagiota Gkertsiou,
• Eleni Pavlidou and
• Stergios Logothetidis

Beilstein J. Nanotechnol. 2018, 9, 1986–1994, doi:10.3762/bjnano.9.189

• in a Vortex apparatus until the drug is completely dissolved. Afterwards, the solution of dexamethasone was added to the CA solution for the subsequent use in the electrospinning process. Electrospinning process The ES-2000S electrospray deposition (ESD) equipment was sued to deposit the sample onto

Al₂O₃/TiO₂ inverse opals from electrosprayed self-assembled templates

• Arnau Coll,
• Sandra Bermejo,
• David Hernández and
• Luís Castañer

Beilstein J. Nanotechnol. 2018, 9, 216–223, doi:10.3762/bjnano.9.23

• fabrication process of the Al2O3/TiO2 inverse opals is schematically outlined in Figure 1 where the starting step can be seen in Figure 1a and consists of the electrospray deposition of the template layer of ordered polystyrene nanoparticles. Only a side view of one row of four nanoparticles is shown for

Electrospray deposition of organic molecules on bulk insulator surfaces

• Antoine Hinaut,
• Rémy Pawlak,
• Ernst Meyer and
• Thilo Glatzel

Beilstein J. Nanotechnol. 2015, 6, 1927–1934, doi:10.3762/bjnano.6.195